IBM AS/400 9401 P03 - Page 66

Save t he En t ire System
Wh at this option will do
• End a ll sub5ystems
• Save the Li censed Internal Code
- Save the ope rating sys tem
- Save the sec urity d at a
- Save the device conf i g ur at ion obj ect s
SYSTEM ' POR TABLE
- Save al l user libr aries (Including l ibraries for licensed progra ms)
- Sa ve all documents and folders
- Save all distribut ion and !Mil obj ec ts
- Star t the controlling subsystem
What thh option will not do
- Save the contents or j ob queues. o utput qu e ues, or data queues t hat
ex ht on the system
Press E nter to c on t inue.
F3 • E xit F 12= Ca nce1
(C) CO PYRIGHT 18M CORP. 19!1e , 1994.
19 The Specify Command Defaults display appears.
Spec ify Coonand Defau lt s
SYS TEM' PORT ABL E
Type ch oices, press Enter.
Tape d evic es ..... ..• T APB l NAMES
P rm pt fo r c ormia nds .. . • , .. N
Check for a cti ve f il es . . .. . . N Y•Yes , N .. No
Fl • Exit Fl2•Cance1
Type the following information:
Tape devices xx xx
Prompt for commands. . N
Check for active files N
Note: For xxxx examples, if the naming convention is *S/36 use TC in the Tape device field.
If the naming convention is *NORMAL, use TAP91 or TAP92 in the Tape device field.
Press the Enter key.
20 The Save display appears with the followi ng message:
Save or restore option completed successfully
Note: If a display other than the Save display appears, follow the instructions on that display.
21 Remove the tape from the tape unit and put it in a safe place.
22 Press F3 (Exit) until you reach the AS/400 Main Menu.
This ends the procedure.
9-4 A S/ 400 9401 In sta ll ation - Models P03 and 105 V3R1
I~