| Aspera Sync | 260
Configuring Watch Service Settings
Configure the Watch Service by using asconfigurator commands with this general syntax:
# /opt/aspera/bin/asconfigurator -x "set_server_data;option,value"
Options and values are described in the following table.
Configuration Options and Values
asconfigurator option
aspera.conf setting
Description Default
watch_log_dir
<log_dir>
Log to the specified directory. This
setting applies to both the Watch
Service and Watch Folders services.
The Aspera logging file (Log Files
on page 348).
watch_log_level
<log_level>
The level of detail for Aspera Watch
Service logging. This setting applies
to both the Watch Service and Watch
Folders services. Valid values are
log, dbg1, and dbg2.
log
watch_db_spec
<db_spec>
Use the specified Redis database,
which is defined with the syntax
redis:ip_address:port[:domain].
This setting applies to both the Watch
Service and Watch Folders services.
redis:127.0.0.1:31415
watchd_max_directories
<max_directories>
The maximum number of directories
that can be watched (combined
across all watches).
This setting is used only on Linux
machines to overwrite the system
value /proc/sys/fs/inotify/
max_user_watches. To
overwrite the system value with the
aspera.conf value, run the setup
procedure in the admin tool:
# aswatchadmin setup
1000000
watchd_max_snapshots
<max_snapshots>
The number of snapshots that are
stored in the database before the
oldest are overwritten.
10000
watchd_snapshot_min_interval
<snapshot_min_interval>
The maximum amount of time
between snapshots. If this period
passes without the minimum number
of changes to trigger a snapshot, a
new snapshot is taken.
3s
watchd_snapshot_min_changes
<snapshot_min_changes>
The minimum number of changes
that trigger a snapshot. If this number
is reached before the snapshot
minimum interval passes, a new
snapshot is taken.
100
To Next Page
Loading...
Need help?
General