MAP 2400 (continued)
039 (continued)
– Power off the system unit.
– Disconnect the power cord from the back of the display.
– Power on the system unit.
– Measure the line voltage at the display end of the power cord.
DO YOU HAVE THE CORRECT LINE VOLTAGE?
Yes No
040
– Power off the system unit.
– Disconnect the power cord from the back of the system unit.
– Measure line voltage at the system unit end of the power cord.
DO YOU HAVE THE CORRECT LINE VOLTAGE?
Yes No
041
– Check the power at the electrical outlet.
– Also check the continuity of the power cord.
– Replace the power cord or plug the machine into a functioning
electrical outlet.
042
– Check the continuity of the line cord between the system unit and
the display.
– Replace the power cord or the power supply.
043
(From steps 031 and 038)
– Power off the system unit.
– Reconnect any disconnected cables.
– Ensure the Advanced Diagnostics Diskette is in drive A.
(Step 043 continues)
2-104
To Next Page
Loading...
