MAP 0020 (continued)
013 (continued)
DID THE SYMPTOM REMAIN?
Yes No
014
Replace the failing drive. If this does not correct the problem, replace
the signal cable.
015
– Power off the system unit and wait 10 seconds.
– Reinstall the signal cable you removed from the drive.
– Perform the same procedure for any remaining drives.
DID THE SYMPTOM REMAIN?
Yes No
016
Replace the failing drive. If this does not correct the problem, replace
the signal cable.
017
You may have a failing riser card.
– Power off the system unit.
– Remove the riser card.
– Power on the system unit.
DID THE SYMPTOM REMAIN?
Yes No
018
Replace the failing riser card.
019
(Step 019 continues)
2-24
To Next Page