326 Load Options for SSP, Reload, and Customize
Select Load Load Program
IPL
Function Option From
Loaded
Time!
Description
1
0000
Disk
SSP
5-9
Normal load.
1
FFOO
Disk
SSP 4 Bypass wrap tests.
2
0000 Diskette SSP 4-12
Load
main storage SSP from diskette and reload
(SSP01) Reload SSP diskettes to disk.
2
FFOO
Diskette
SSP
1-5
Load
main storage SSP from diskette, bypass wrap
(SSP01)
Reload tests, and reload SSP diskettes to disk.
3 0000
3
Diskette
61
DCP
4-8
Sense devices, assemble
UDT
and
run
I/O wraps.
3 1000
Diskette
61
AUTO
4-8
Sense devices, assemble UDT, and run I/O wraps.
CONFIC Prompts user for input
about
the system. Device,
keyboard, serial number, printer address.
3
CECE2
Diskette
61
AUTO
4-8
Sense devices, assemble UDT, and run I/O wraps.
CONFIC Prompts user for input about the system. Device,
keyboard, serial number, printer address.
3
FF003
Diskette
61
DCP
1-2 Bypass wrap tests; sense devices, assemble UDT.
3
FFF03
Diskette
61
DCP
1
Load
DCP
from diskette, bypass channel wraps.
3
22224
Diskette
61
INIT
4-8
Initialize the disk, run wraps.
3
22FF4
Diskette
61
INIT
2-6 Initialize the disk, bypass wraps.
1
IPL times are approximate in minutes.
2
The CECE load option displays the hardware configuration. You can select
an
option to change the
machine serial number
or
to change the printer address. After you select the option, follow the
prompts to completion.
3
The
DCP
Main menu appears and the following options are available: System Customize (insert
diskette 62), Program
Patch (insert diskette 62), System Records List (insert diskette 62), Network
Analysis (insert diskette 61),
RPQ
Utilities, Supervisor Options and Change System Printer. After you
select the option, follow the prompts to completion.
4
Select the disk drive to be initialized and wait until
it
is done initializing. When disk initialization is
completed, the screen will state
that
the disk
is
100% initialized.
You
may then perform
an
AUTO
CONFIG.
Section
3.
General Procedures 3-9
To Next Page
Loading...
