IBM System/36 - Load Options for DCP

336 Load Options for DCP
Select IPL IPL Program
IPL
Function Option
From Loaded
Timet
Description
2
F800
3
Disk
DCP 2-6 Load DCP from disk, bypass wrap tests.
2
F80P Disk DCP
2-8
Load DCP from disk, run wraps.
2
F8F03
Disk
DCP 2-5 Load DCP from disk, no disk motor start or wrap.
3
FA03
Diskette 61 DCP No
Use only when directed. See "160 Isolating Main
IPL Storage Problems" on page 1-10. Stop at the end
of MSP tests to allow changing of control panel
input.
3
FC03 Diskette 61
DCP No Use only when directed. See "Procedure 123" on
IPL
page 1-7. Loop on MSP tests and allow no
unsatisfactory 2K blocks
of main store.
3
FF003
Diskette 61
DCP 1-2 Bypass wrap tests; sense devices, assemble UDT.
3
FF003
Diskette 61
DCP 1 Load DCP from diskette, bypass channel wraps.
3
0000
3
Diskette 61
DCP 4-8 Sense devices, assemble UDT and run I/O wraps.
3
22224
Diskette 61
INIT 4-8 Initialize the disk, run wraps
3
22FF4
Diskette
61
INIT 2-6 Initialize the disk, bypass wraps
3
FF003
Diskette 61 DCP
1-2 Bypass wrap tests; sense devices, assemble UDT
1
IPL times are approximate in minutes.
2
The CECE load option displays the hardware configuration. You can select an option to change the
machine serial number or to change the printer address. After you select the option, follow the
prompts to completion.
3
The
DCP Main menu appears and the following options are available:
System Customize (insert
diskette 62),
Program Patch (insert diskette 62), System Records List (insert diskette 62), Network
Analysis (insert diskette
61), RPQ Utilities, SupervisorOptions and Change System Printer. After you
select the option, follow the prompts to completion.
4
Select the disk drive to be initialized and wait until it is done initializing. When disk initialization is
completed, the screen will state that the disk is 100% initialized. You may then perform an AUTO
CONFIG.
3-14 5363 Maintenance Information