328 Service Procedures under SSP
Note:
To
load SSP,
see
"320 Loading the SSP" on page
.3-7.
Enter one
of
the following SSP procedures on the command line:
• SYSTEST (system test):
Disk exerciser
Diskette exerciser
Display station exerciser
Main storage processor exerciser
Printer exerciser
Communications exerciser
Tape exerciser
Local area network
• COMMTEST (communications diagnostic tests):
Basic communications diagnostic test
Additional communications diagnostic tests
- IBM LPDA local and remote modem diagnostic tests
- Remote loop back wrap tests
• STATEST (SDLC station test)
• BSCTEST (BSC online test)
• SDLCTEST (SDLC online test)
• ERAP (error recording analysis program):
System summary
Elapsed time counters
Reports for all devices
Single reports by device
• TESTREQ (test request):
Display verification
Work station printer verification
Configuration data
ERAP (reports associated with work stations)
• PROBLEM (problem determination):
Diskette
Local work station
Communications
Tape
Local area network
3-10 5363 Maintenance Information
To Next Page
Loading...
