406 Feature Power Supply Removal
1.
Power off the 5363.
2.
Disconnect the power cord from the 5363.
3.
Remove the covers ("305 Cover Removal" on page 3-2).
4.
Disconnect the power cable connected to the base power supply.
5.
Disconnect the power supply
~onnectors
to the
Bl
board (P4, P5), and to the tape drive (P11),
if
installed.
6.
Remove the two screws from the rear
of
the
5363
that
hold the feature power supply, and the screws
that
hold the forward base tab
of
the power supply to the
5363
frame.
7.
Slide the power supply toward the rear
of
the
5363
to clear the tabs
on
the frame and lift upward to
remove.
8.
Set the line voltage switch to the proper voltage for your 5363.
9.
Install the new power supply by performing the previous steps in reverse order. Ensure that you slide the
power supply under the tabs on the
5363
frame.
Section
4.
Power Procedures 4-3
To Next Page
Loading...
