Key in This
Press
SSP
Name This Key Description or Action
POWER
OFF
Enter Closes files and terminates SSP.
(Does
not
power off the system.)
PROBLEM Enter Gives instructions to perform on-line problem determination.
PTF
Help Gives the prompt to install
or
remove
PTFs
(program temporary fixes)
or
MPTFs (microcode program temporary fixes) to disk.
SDLCTEST Enter
Gives the prompt to select options from menus to perform the SDLC on-line
tests.
SERVICE Help Shows the menu with options to run service aid procedures.
SERVLOG
Help Gives the prompt to add entries to the system service log.
SETCOMM
Help Gives the prompt to change some communications parameters.
See
"930
Displaying Communications Configuration Status" on page
9-5.
SETDUMP
Help
Gives the prompt to set the address compare dump values for programs
running in main storage.
SMF
Help Shows the menu to select options from menus to measure system actions.
SMFPRINT
Help Gives the prompt to print a formatted report
of
the data collected by the
system measurement program.
SMFSTART Help Gives the prompt to start the system measurement program.
SMFSTOP Enter Stops the system measurement program.
START
Help Shows a menu that lets jobs run, start, or print. The option to start system
service authorization lets you specify a display station to
be
used to enter any
procedure or command to service the system.
STATEST Enter
Gives the prompt to select options from menus to perform the remote work
station tests.
STOP
Help Shows a menu
that
prevents jobs from running, starting, or printing. The
option to start system service authorization lets you return a display station to
its normal use.
SYSTEST Enter Shows the menu to select exercisers to perform diagnostic testing
of
the
system.
No
customer jobs can be running.
TAPEINIT
Help Shows the menu with options to create the label on the tape volume.
TAPESTAT Enter
Gives the prompt to display or print the selected system data for the tape
volumes.
TESTDSKT
Help Shows the menu with options to perform tests on the diskette drive and
media.
TESTREQ Enter
Shows the menu with options to perform the local and remote work station
verification tests.
TRACE
Help
Gives the prompt to keep a record
of
selected events on the system.
VARY Help
Gives the prompt to change the status
of
a display station, a printer, the
system printer, or the diskette drive to on-line or off-line.
3-12 5363 Maintenance Information
To Next Page
Loading...
Need help?
General