Appendix D. Power cords
For your safety, IBM provides a power cord with a grounded attachment plug to use with this IBM
product. To avoid electrical shock, always use the power cord and plug with a properly grounded outlet.
IBM power cords used in the United States and Canada are listed by Underwriter's Laboratories (UL) and
certified by the Canadian Standards Association (CSA).
Attention: The DCS3700 does not support 90-136V AC sources. It supports 200-240V AC sources only.
Ensure that the AC input is appropriate for the DCS3700 before turning the power switches to the on
position.
For units intended to be operated at 230 volts (U.S. use): Use a UL-listed and CSA-certified cord set
consisting of a minimum 18 AWG, Type SVT or SJT, three-conductor cord, a maximum of 15 feet in
length and a tandem blade, grounding-type attachment plug rated 15 amperes, 250 volts.
For units intended to be operated at 230 volts (outside the U.S.): Use a cord set with a grounding-type
attachment plug. The cord set should have the appropriate safety approvals for the country in which the
equipment will be installed.
IBM power cords for a specific country or region are usually available only in that country or region.
Table 26. IBM power cords
IBM power
cord part
number
Feature
code Description Used in these countries or regions
39M5262 9870 2.5m, 15A/250V,
C19 to NEMA
6-15P
Antigua and Barbuda, Aruba, Bahamas, Barbados, Belize, Bermuda,
Bolivia, Brazil, Caicos Islands, Canada, Cayman Islands, Costa Rica,
Colombia, Cuba, Dominican Republic, Ecuador, El Salvador, Guam,
Guatemala, Haiti, Honduras, Jamaica, Japan, Mexico, Micronesia
(Federal States of), Netherlands Antilles, Nicaragua, Panama, Peru,
Philippines, Taiwan, United States of America, Venezuela
39M5274 9871 2.5m, 15A/250V,
C19 to NEMA
L6-15P
Canada, Colombia, Mexico, United States
© Copyright IBM Corp. 2011 153
To Next Page
Loading...
Need help?
General