Statement 3:
CAUTION:
When laser products (such as CD-ROMs, DVD drives, fibre optic devices, or transmitters) are
installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could result in exposure to
hazardous laser radiation. There are no serviceable parts inside the device.
v Use of controls or adjustments or performance of procedures other than those specified herein
might result in hazardous radiation exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view directly with optical
instruments, and avoid direct exposure to the beam.
Attention: When you handle static-sensitive devices, take precautions to avoid damage from static
electricity. For details about handling static-sensitive devices, see “Handling static-sensitive devices” on
page 25.
Complete the following steps to install an SFP module:
1. Remove the SFP module from its static-protective package.
2. Remove the protective cap from the SFP module, as shown in Figure 23. Save the protective cap for
future use.
3. Remove the protective cap from the SFP port. Save the protective cap for future use.
4. Insert the SFP module into the host port until it clicks into place. See Figure 24 on page 46.
o
Protective
cap
Wire
tab
SFP
module
90
Figure 23. SFP module and protective cap
Chapter 3. Cabling the DCS3700 45
To Next Page
Loading...
Need help?
General