IBM System x3100 M4 Problem Determination And Service Guide

Installing the lower bezel
This procedure applies only to the 5U server model with hot-swap power supplies
(Model name: 2582-F4x).
To install the lower bezel on the 5U server model with hot-swap power supplies
(Model name: 2582-F4x), complete the following steps.
1. Insert the two bottom tabs on the lower bezel into the corresponding holes in
the front of the chassis.
2. Rotate the top of the lower bezel up to the chassis; then, press the blue-colored
release tab on the right side of the lower bezel and completely close the lower
bezel until it locks securely into place.
3. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Chapter 5. Removing and replacing server components 173

IBM System x3100 M4 Specifications

General

Memory	Up to 32 GB DDR3 ECC UDIMM
Memory Slots	4 DIMM slots
Form Factor	Tower
Chipset	Intel C202
Processor Sockets	1
Processor	Intel Xeon E3-1200 v2 series, Intel Pentium series, Intel Celeron series
Storage	Up to 4x 3.5-inch
Power Supply	350W
Hard Drive Bays	4 x 3.5"
RAID Support	RAID 0, 1, 10
Network Interface	Gigabit Ethernet
Expansion Slots	1 x PCIe 3.0 x16, 1 x PCIe 2.0 x4
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server