To install a hot-swap hard disk drive on the 5U server model that have hot-swap
power supplies (Model name: 2582-F4x), complete the following steps.
2.5-inch hot-swap
hard disk drive
Drive handle
Activity LED
(green)
Error LED
(yellow)
Release latch
1. Touch the static-protective package that contains the drive to any unpainted
metal surface on the server; then, remove the drive from the package and place
it on a static-protective surface.
2. Make sure that the drive tray handle is in the open position.
3. Align the drive assembly with the guide rails in the bay; then, carefully slide the
drive assembly into the drive bay until the drive stops.
4. Rotate the drive tray handle to the closed position.
5. Check the hard disk drive status indicator to make sure that the hard disk drive
is operating correctly. (You might have to restart the server for the drive to be
recognized.) If the yellow hard disk drive status LED for a drive is lit
continuously, it indicates that the drive is faulty and must be replaced. If the
green hard disk drive activity LED is flashing, this indicates that the drive is
being accessed.
Note: If the server is configured for RAID operation using a ServeRAID
controller, you might have to reconfigure the disk arrays after you replace hard
disk drives. See the ServeRAID documentation for additional information about
RAID operation and complete instructions for using ServeRAID Manager.
6. Install the lower bezel (see “Installing the lower bezel” on page 173).
7. Install and lock the side cover (see “Installing the side cover” on page 167).
Removing a memory module
To remove a dual inline memory module (DIMM) on 4U server models with
non-hot-swap power supplies, complete the following steps. For the 5U server
model with hot-swap power supplies (Model name: 2582-F4x), please see the next
sub-section.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 163.
200 IBM System x3100 M4 Type 2582: Problem Determination and Service Guide
To Next Page
Loading...
Need help?
General
