IBM System x3100 M4 Problem Determination And Service Guide

Installing the upper bezel
This procedure applies only to the 5U server model with hot-swap power supplies
(Model name: 2582-F4x).
To install the upper bezel on the 5U server model with hot-swap power supplies
(Model name: 2582-F4x), complete the following steps.
1. Insert the two tabs on the right-side of the upper bezel into the corresponding
holes on the right side of the chassis.
Bezel clips
2. Rotate the upper bezel to the left side of the chassis until the bezel clips are
aligned with the corresponding indentations on the left side of the chassis and
snap them into place.
3. Install the lower bezel (see “Installing the lower bezel” on page 173).
4. Install and lock the side cover (see “Installing the side cover” on page 167).
5. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Chapter 5. Removing and replacing server components 175

IBM System x3100 M4 Specifications

General

Memory	Up to 32 GB DDR3 ECC UDIMM
Memory Slots	4 DIMM slots
Form Factor	Tower
Chipset	Intel C202
Processor Sockets	1
Processor	Intel Xeon E3-1200 v2 series, Intel Pentium series, Intel Celeron series
Storage	Up to 4x 3.5-inch
Power Supply	350W
Hard Drive Bays	4 x 3.5"
RAID Support	RAID 0, 1, 10
Network Interface	Gigabit Ethernet
Expansion Slots	1 x PCIe 3.0 x16, 1 x PCIe 2.0 x4
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server