IBM System x3100 M4 Problem Determination And Service Guide

Screws
11. Lift the hot-swap backplane out of the lower lip on the drive cage and set it
aside.
12. If you are instructed to return the SAS/SATA hard disk drive backplane, follow
all packaging instructions, and use any packaging materials for shipping that
are supplied to you.
Installing the hot-swap hard disk drive backplane
This procedure applies only to the 5U server model with hot-swap power supplies
(Model name: 2582-F4x).
To install the hard disk drive backplane on the 5U server model with hot-swap
power supplies (Model name: 2582-F4x), complete the following steps.
1. Place the bottom edge of the hot-swap hard disk drive backplane in the lower
lip of the drive cage.
2. Connect the power, signal and configuration cables to the hard disk drive
backplane.
Note: Make sure that Port 1 on the hardware ServeRAID is connected to Port
1 on the backplane. Likewise, Port 0 on the hardware ServeRAID should be
connected to Port 0 on the backplane.
224 IBM System x3100 M4 Type 2582: Problem Determination and Service Guide

IBM System x3100 M4 Specifications

General

Memory	Up to 32 GB DDR3 ECC UDIMM
Memory Slots	4 DIMM slots
Form Factor	Tower
Chipset	Intel C202
Processor Sockets	1
Processor	Intel Xeon E3-1200 v2 series, Intel Pentium series, Intel Celeron series
Storage	Up to 4x 3.5-inch
Power Supply	350W
Hard Drive Bays	4 x 3.5"
RAID Support	RAID 0, 1, 10
Network Interface	Gigabit Ethernet
Expansion Slots	1 x PCIe 3.0 x16, 1 x PCIe 2.0 x4
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server