Table 10. Integrated management module error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 4, “Parts listing, Types 4255, 7945, and 7949 server,” on page 157 to determine which
components are customer replaceable units (CRU) and which components are field replaceable units
(FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
DHCP[%1] failure, no IP address
assigned.
(%1 = IP address,
xxx.xxx.xxx.xxx)
Info A DHCP server has failed to
assign an IP address to the IMM.
1. Make sure that the network
cable is connected.
2. Make sure that there is a
DHCP server on the network
that can assign an IP address
to the IMM.
Remote Login Successful. Login
ID: %1 from %2 at IP address %3.
(%1 = user ID; %2 =
ValueMap(CIM_Protocol
Endpoint.ProtocolIFType;
%3 = IP address, xxx.xxx.xxx.xxx)
Info A user has successfully logged in
to the IMM.
No action; information only.
Attempting to %1 server %2 by
user %3.
(%1 = Power Up, Power Down,
Power Cycle, or Reset;
%2 = IBM_ComputerSystem
.ElementName;
%3 = user ID)
Info A user has used the IMM to
perform a power function on the
server.
No action; information only.
Security: Userid: '%1' had %2
login failures from WEB client at
IP address %3.
(%1 = user ID;
%2 = MaximumSuccessive
LoginFailures (currently set to 5 in
the firmware);
%3 = IP address, xxx.xxx.xxx.xxx)
Error A user has exceeded the
maximum number of
unsuccessful login attempts from
a Web browser and has been
prevented from logging in for the
lockout period.
1. Make sure that the correct
login ID and password are
being used.
2. Have the system
administrator reset the login
ID or password.
Security: Login ID: '%1' had %2
login failures from CLI at %3.
(%1 = user ID; %2 =
MaximumSuccessive
LoginFailures (currently set to 5 in
the firmware);
%3 = IP address, xxx.xxx.xxx.xxx)
Error A user has exceeded the
maximum number of
unsuccessful login attempts from
the command-line interface and
has been prevented from logging
in for the lockout period.
1. Make sure that the correct
login ID and password are
being used.
2. Have the system
administrator reset the login
ID or password.
Remote access attempt failed.
Invalid userid or password
received. Userid is '%1' from WEB
browser at IP address %2.
(%1 = user ID; %2 = IP address,
xxx.xxx.xxx.xxx)
Error A user has attempted to log in
from a Web browser by using an
invalid login ID or password.
1. Make sure that the correct
login ID and password are
being used.
2. Have the system
administrator reset the login
ID or password.
Remote access attempt failed.
Invalid userid or password
received. Userid is '%1' from
TELNET client at IP address %2.
(%1 = user ID; %2 = IP address,
xxx.xxx.xxx.xxx)
Error A user has attempted to log in
from a Telnet session by using an
invalid login ID or password.
1. Make sure that the correct
login ID and password are
being used.
2. Have the system
administrator reset the login
ID or password.
148 IBM System x3650 M3 Types 4255, 7945, and 7949: Problem Determination and Service Guide
To Next Page
Loading...
