Table 10. Integrated management module error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 4, “Parts listing, Types 4255, 7945, and 7949 server,” on page 157 to determine which
components are customer replaceable units (CRU) and which components are field replaceable units
(FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
The Chassis Event Log (CEL) on
system %1 cleared by user %2.
(%1 = CIM_ComputerSystem
.ElementName; %2 = user ID)
Info A user has cleared the IMM event
log.
No action; information only.
IMM reset was initiated by user
%1.
(%1 = user ID)
Info A user has initiated a reset of the
IMM.
No action; information only.
ENET[0] DHCP-HSTN=%1,
DN=%2, IP@=%3, SN=%4,
GW@=%5, DNS1@=%6.
(%1 = CIM_DNSProtocol
Endpoint.Hostname;
%2 = CIM_DNSProtocol
Endpoint.DomainName;
%3 = CIM_IPProtocol
Endpoint.IPv4Address;
%4 = CIM_IPProtocolEndpoint.
SubnetMask;
%5 = IP address, xxx.xxx.xxx.xxx;
%6 = IP address, xxx.xxx.xxx.xxx)
Info The DHCP server has assigned
an IMM IP address and
configuration.
No action; information only.
ENET[0] IP-Cfg:HstName=%1,
IP@%2, NetMsk=%3, GW@=%4.
(%1 = CIM_DNSProtocol
Endpoint.Hostname;
%2 = CIM_StaticIPSettingData.
IPv4Address;
%3 = CIM_StaticIPSettingData.
SubnetMask;
%4 = CIM_StaticIPSettingData.
DefaultGatewayAddress)
Info An IMM IP address and
configuration have been assigned
using client data.
No action; information only.
LAN: Ethernet[0] interface is no
longer active.
Info The IMM Ethernet interface has
been disabled.
No action; information only.
LAN: Ethernet[0] interface is now
active.
Info The IMM Ethernet interface has
been enabled.
No action; information only.
DHCP setting changed to by user
%1.
(%1 = user ID)
Info A user has changed the DHCP
mode.
No action; information only.
IMM: Configuration %1 restored
from a configuration file by user
%2.
(%1 = CIM_ConfigurationData.
ConfigurationName;
%2 = user ID)
Info A user has restored the IMM
configuration by importing a
configuration file.
No action; information only.
Chapter 3. Diagnostics 149
To Next Page
Loading...
Need help?
General
