Icom i9100

196
18
CONTROL COMMAND
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
q, w Satellite memory channel number
0000–0019 : Satellite memory channel 00 to 19
e–u Operating frequency setting
See‘•Operatingfrequency.’(p.190)
i, o Operating mode setting
See‘•Operatingmode.’(p.190)
!0 Data mode setting
1 byte data (XX)
00: Data mode OFF
01: Data mode ON
!1 Tone setting
0X
!1
0: OFF
1: Tone
2: TSQL
3: DTCS
!2 Digital squelch setting
X0
!2
0: Digital squelch function OFF
1: Digital call sign squelch function ON (DSQL)
2: Digital code squelch function ON (CSQL)
!3–!5 Repeater tone frequency setting
!6–!8 Tone squelch frequency setting
See‘•Repeatertone/tonesquelchfrequencysetting.’
(p. 193)
!9–@1 DTCS code setting
See‘•DTCScodeandpolaritysetting.’(p.193)
@2 Digital code squelch setting
See‘•Digitalcodesquelchsetting.’(p.193)
@3–#0 Destination call sign setting
(8characters;xed)
#1–#8 R1 (Access/Area repeater) call sign setting
(8characters;xed)
#9–$6 R2 (Link/Gateway repeater) call sign setting
(8characters;xed)
See‘•DVTXcallsignssetting.’(p.194)
$7–%5 Memory name setting
9 characters (Fixed)
See‘•Charactercodesetting.’(p.190)
NOTE:
•Thesamedataase–$6 are stored in e–$6.
•e–$6 is used for the uplink frequency (transmit).
•e–$6 is used for the downlink frequency (re-
ceive).
• Satellite memory content setting
Command : 1A 07
X
e〜ui、o!0!2@2!1 !3〜!5 !9〜@1!6〜!8
X…… XXXXXXXX0XX0XXXXXXXXXX XXXX XXXXXX XXXX
q、w
#9〜$6
XX…… XX ……………… ……XX XX
e〜$6 $7〜%5#1〜#8
XX…… XX
@3〜#0
XX…… XX