Icom i9100

200
20
OPTIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
CT-17 c i -v l e v e l c o n v e r t e r u n i t
For remote transceiver control using a
personal computer equipped with an
RS-232C port. You can changefre-
quencies, operating mode, memory
channels, etc., via your computer.
• AG-25 w e a t h e r -p r o o f p r e a m p l i f i e r (for 144 MHz Band)
• AG-35 w e a t h e r -p r o o f p r e a m p l i f i e r (for 430 MHz Band)
External all-weather, mast mounting preamplifiers for com-
pensating for coaxial cable loss.
• AG-2400 d o w n c o n v e r t e r u n i t
All-weather, satellite down converter with superior NF and
gain.
Input frequency : 2400–2402 MHz
Output frequency : 144–146 MHz
Conversion gain : More than 25 dB
Total NF : Less than 1.5 dB
• OPC-1529R d a t a c o m m u n i c a t i o n c a b l e (RS-232C type)
Allows low-speed data communication in the DV mode, and
receiving a GPS data from a third-party GPS receiver.
• OPC-599 a d a p t e r c a b l e
13-pin, ACC connector to 7-pin + 8-pin ACC connector.
• MB-123 c a r r y i n g h a n d l e
Convenient when carrying the transceiver.
The same as that attached with the transceiver.
• UT-121 digital u n i t
Allows the DV mode operation with the IC-9100.
• CS-9100 c l o n i n g s o f t w a r e
Use this software to program settings, memory channels
and set mode contents quickly and easily via your PC’s
USB port.
A USB cable is required. (A-B type, purchase separately)
• RS-BA1 ip r e m o t e c o n t r o l s o f t w a r e
To remotely control radios using the RS-BA1, BE SURE
that you comply with your local regulations.
Approved Icom optional equipment is designed for
optimal performance when used with an Icom trans-
ceiver.
Icom is not responsible for the destruction or damage
to an Icom transceiver in the event the Icom trans-
ceiver is used with equipment that is not manufac-
tured or approved by Icom.