Icom IC-450 - Set Mode Configuration; Backlight, Brightness, Voice Recorder Settings; Noise Cancel, Reset, Mic Hanger

19
4
SET MODE
4
D Backlight
You can change the backlight modes for night-time and low-
light operations. Select the desired mode. (Default: ON)
•Off: No Backlight.
•Auto: Lights for 5 seconds when any key except [PTT] is pushed,
or when a Selcall signal is transmitted or received.
•Auto2: Lights for 5 seconds when any key except [PTT] is pushed,
when Selcall signal is transmitted, or when the display is
changed.
•On: Backlight is continuously lit.
D Brightness
Adjust the backlight brightness level between 0 (Minimum)
and 7 (Maximum). (Default: 4)
D Voice Recorder
This function records a message. Turn the function ON or
OFF. (Default: ON)
D Clear Rec Data
Youcancleartherecordedaudiobyselecting“Yes”inthis
menu item. (Default: No)
This message is displayed while
clearing the recorded data.
D Noise Cancel
This function allows clear communication by reducing the
surrounding noise, especially the low frequency noise
received by the microphone. Turn the function ON or OFF.
(Default: OFF)
D Reset
You can reset the transceiver’s settings to the factory
defaultsbyselecting“Yes”inthismenuitem. (Default:No)
D Mic Hanger
You can activate the AF Mute and the Volume Control
functions. Turn the function ON or OFF. (Default: OFF)
This message is displayed while
resetting to the factory defaults.