Icom IC-450 - Other Functions - Data and Reset; Data Cloning and All Reset

34
9
OTHER FUNCTIONS
■ Data cloning
Data cloning enables you to transfer the data quickly and
easily from a PC to your transceiver, using the optional CS-450
c l o n i n g s o f t w a r e .
Data cloning can be done to or from a PC, using the CS-450
c l o n i n g s o f t w a r e and the optional OPC-1122U (USB type)
cloning cable.
•RefertotheCS-450c l o n i n g s o f t w a r e ’s Help file for details.
to the [MIC] connector
OPC-1122U
(USB type)
to a USB port
PC
IC-450
■ All reset
The function display may occasionally display erroneous
information. This may be caused externally by static
electricity or by other factors. If this problem occurs, turn
OFF the power, and then after a few seconds, turn ON the
power again. If the problem persists, perform the following
procedure.
IMPORTANT!:
Resetting the transceiver sets all values to their defaults.
While holding down ➥
, , and , hold down for
2 seconds to turn ON the transceiver power
.
 •ResetstheCPU.
 •“AllReset”appearsonthefunctiondisplay.
This message is displayed while
resetting to the factory defaults.