Icom IC-450 - Scan Preparation; Scanning Preparation Steps

22
6
SCAN
■ Scanning preparation
The IC-450 scans all tagged channels when a scan is activated.
When the IC-450 finds a busy channel, it can be set to pause, or
to resume after a pause. (Except for the Repeater search scan).
•Seepages17and23forthedetailsontheScanResumefunction.
(Default: 5sec No Signal)
D Selecting the scan mode
Push q to enter the menu mode.
Push [ w ] or []toselect“ScanMode.”
 (“Scan”>“ScanMode”)
Push [ e ] or [] to select the desired scan mode, and
then push [] to set.
 •“ (OpenScan),”“ (GroupScan),”“ (Priority Scan),” or
“ (Repeater Scan)” is displayed on the standby mode screen.
Push r to exit the menu mode.
D Tag channel setting
Before setting the tag channels, you must select the desired
scan mode, as described in the left column.
Push q
to enter the menu mode.
Push [ w ] or []toselect“Tag.”
 (“Scan”>“Tag”)
Push [ e ] or [] to select a channel, and then select ON
or OFF to set it as a Tag channel, and then push Push
[] to set it.
 •“ ” appears when the tag setting is ON (The channel is set as
a scan channel).
Appears
Example:
When channel 01 is set as a tag channel for open scan.
To speed up the scan:
For an Open scan, cancel the Tags to skip undesired channels
such as busy channels.
For Group scan, set only often-used channels as tag channels.
All memory channels may be set as tag channels by default.
When Open scan is selected.
Select a scan mode
Appears