Icom IC-718 - Transmitter Adjustments

N Memory channels
The transceiver has 101 memory channels. Memory
mode is very useful for quick change to often-used
frequencies.
All 101 memory channels are tuneable which means
the programmed frequency can be tuned temporarily
with the main dial, etc. in memory mode.
MEMORY
CHANNEL
MEMORY
CHANNEL
NUMBER
CAPABILITY
TRANSFER
TO VFO
OVER-
WRITING
CLEAR
Regular memory
channels
1–99
One frequency and one mode in each
memory channel.
Yes Yes Yes
Scan edge
memory
channels
P1, P2
One frequency and one mode in each
memory channel as scan edges for
programmed scan.
Yes Yes No
N Memory channel selection
D Using the [∫]/[√] keys
q Push [VFO/MEMO] to select memory mode.
w Push [∫]/[√] several times to select the desired
memory channel.
• Push and hold [∫]/[√] for continuous selection.
•
[UP] and [DN] on the microphone can also be used.
e To return to VFO mode, push [VFO/MEMO] again.
D Using the keypad
q Push [VFO/MEMO] to select memory mode.
w Push [F-INP ENT].
e Push the desired memory channel number using
the keypad.
• Enter 100 or 101 to select scan edge channel P1 or P2,
respectively.
r Push [∫] or [√] to set the memory channel.
[EXAMPLE]
To select the memory channel 3;
- Push [F-INP ENT], [7 3], then push [∫] or [√].
To select the memory channel 12;
- Push [F-INP ENT], [1.8 1], [3.5 2], then push [∫] or
[√].
To select the scan edge channel P1;
- Push [F-INP ENT], [1.8 1], [50 0], [50 0], then push
[∫] or [√].
To select the scan edge channel P2;
- Push [F-INP ENT], [1.8 1], [50 0], [1.8 1], then push
[∫] or [√].
VFO/MEMO
VFO/MEMO
Keypad
F-INP
ENT
6
99
MEMORY OPERATION