N Tone scan
The transceiver can detect subaudible tones in a re-
ceived signal. By monitoring a signal that is being
transmitted on a repeater input frequency, you can
determine the tone frequency required to access the
repeater.
q Set the desired frequency or memory channel to
be checked for a tone frequency.
w Push [AM/FM] several times to select FM mode.
e Push and hold [TONE] (MF7) for 1 sec. to enter
tone frequency screen.
r Push [Y] (F-1) or [Z] (F-2) to check the repeater
tone frequency or tone squelch frequency, respec-
tively.
t Push [T-SCAN] (F-6) to start the tone scan.
• “SCAN” blinks while scanning.
y When a matching tone frequency is detected, the
tone scan pauses.
• The tone frequency is set temporarily on a memory
channel. Program the memory channel to store the
tone frequency permanently.
• The decoded tone frequency is used for the repeater
tone frequency or tone squelch frequency.
u To stop the scan, push [T-SCAN] (F-6).
• Push and hold [DEF] (F-4) for 1 sec. to select the de-
fault frequency.
i Push [EXIT/SET] to exit tone frequency screen.
F-1 F-2
EXIT/SET
AM/FM
TONE
T-SCAN
DEF
F-4
F-6
111
7
SCANS
To Next Page
Loading...
