128
10
SET MODE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
N Others set mode
Calibration Marker OFF
This item is used for a simple frequency check of the
transceiver. (default: OFF)
See
p. ?? for calibration procedure.
NOTE: Turn the calibration marker OFF after
checking the frequency of the transceiver.
Beep (Confirmation) ON
A beep sounds each time a switch is pushed to
confirm it. This function can be turned OFF for silent
operation. (default: ON)
The beep output level can be set in level set mode.
(p. ??)
Beep (Band Edge) ON (Default)
A beep sounds when an operating frequency enters
or exits an amateur band. This functions indepen-
dent of the confirmation beep setting (above).
The beep output level can be set in level set mode.
(p. ??)
• OFF : Band edge beep OFF
• ON (Default) : Band edge beep sounds when an
operating frequency enters or exits a
default amateur band. (default)
• ON (User) : A beep sounds when an operating
frequency enters or exits an ama-
teur band that is set in BAND EDGE
screen.
(p. ??)
• ON (User) & TX Limit
: A beep sounds when an operating
frequency enters or exits an ama-
teur band that is set in BAND EDGE
screen and TX is limited out of the
band. (p. ??)
Beep Sound 1000Hz
Sets the desired key-touch beep frequency within
500 to 2000 Hz in 10 Hz steps. (default: 1000 Hz)
RF/SQL Control RF+SQL
The [RF/SQL] control can be set as the RF/squelch
control (default), the squelch control only (RF gain is
fixed at maximum) or ‘Auto’ (RF gain control in SSB,
CW and RTTY; squelch control in AM and FM).
See
pgs. ??, ?? for details.
• RF+SQL : [RF/SQL] control as RF/squelch control
(default)
• SQL : [RF/SQL] control as squelch control
• AUTO : [RF/SQL] control as RF gain control in
SSB, CW and RTTY; squelch control in
AM and FM
Quick Dualwatch ON
When this item is set to ON, pushing and holding
[DUALWATCH] for 1 sec. sets the sub readout fre-
quency to the main readout frequency and activates
dualwatch operation.
• OFF : Quick dualwatch OFF
• ON : Quick dualwatch ON (default)
To Next Page
Loading...
