Icom IC-718 - Memory Scan Operation; Select Memory Scan Operation

N Memory scan operation
q Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
w Select memory mode.
e Push [SCAN] (F-5) to select the scan screen.
r Set [RF/SQL] open or closed.
• See p. ?? for squelch condition.
• If the
[RF/SQL] control function is set as “AUTO,” the
squelch is always open in SSB, CW and RTTY modes.
(pgs. ??, ??, ??)
t Push [MEMO] (F-1) to start the memory scan.
• “ ” and decimal points blink while
scanning.
y When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
u To cancel the scan, push [MEMO] (F-1) .
• Rotating the main dial also cancels the scan.
2 or more memory channels must be programmed
for memory scan to start.
N Select memory scan operation
q Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
w Select memory mode.
e Push [SCAN] (F-5) to select the scan screen.
r Set [RF/SQL] open or closed.
• See p. ?? for squelch condition.
• If the
[RF/SQL] control function is set as “AUTO,” the
squelch is always open in SSB, CW and RTTY modes.
(pgs. ??, ??, ??)
t Push [MEMO] (F-1) to start the memory scan.
• “ ” and decimal points blink while
scanning.
y Push [SEL No.] (F-4) several times to select the
select scan number from
( 1, ( 2, ( 3 and ( 1,2,3.
u Push [SELECT] (F-3) to start select memory scan;
push [SELECT] (F-3) again to return to memory
scan, if desired.
• “ ” blinks instead of
“
” during select memory scan.
i When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
o To cancel the scan, push [MEMO] (F-1).
• Rotating the main dial also cancels the scan.
2 or more memory channels must be designated
as select memory channels, as well as the same
select scan channel number, for select memory
scan to start.
F-1 F-5
EXIT/SET
Main dial
[RF/SQL]
SCANMEMO
F-3
SELECT
109
7
SCANS