Icom IC-718 - Page 25

N Fine programmed scan/Fine ∂F scan
In fine scan (programmed or ∂F), the scan speed de-
creases when the squelch opens, but the transceiver
keeps scanning. The scanning tuning step shifts from
50 Hz to 10 Hz when the squelch opens.
q Push [EXIT/SET] several times to close a multi-
function screen, if necessary.
w Push [SCAN] (F-5) to select the scan screen.
e Set for programmed scan or ∂F scan as described
on previous page.
r Push [PROG] (F-1) or [∂F] (F-2) to start a scan.
• “ ” or “ ” and decimal
points blink while scanning.
t Push [FINE] (F-3) to start a fine scan.
• “ ” or “ ”
blinks instead of “
” or “ , ”
respectively.
y When the scan detects a signal, the scan speed
decreases but scan does not stop.
u Push [PROG] (F-1) or [∂F] (F-2) to stop the scan;
push [FINE] (F-3) to cancel the fine scan.
• Rotating the main dial also cancels the scan.
i Push and hold [RECALL] (F-5) for 1 sec. to recall
the frequency that is set before starting the scan, if
desired.
F-1 F-5
EXIT/SET
Main dial
[RF/SQL]
PROG SCAN
RECALL
F-3
F-2
∂F
FINE
108
7
SCANS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21