97
14
CONTROL COMMAND
2001 NEW 2001 NEW
• Command table (continued)
DD
To send/read memory contents
When sending or reading memory contents, additional code
as follows must be added to appoint the memory channel.
➥ Additional code: 0000–0102
(0100=P1, 0101=P2, 0102=Call)
DD
Band stacking register
To send or read the desired band stacking register’s con-
tents, combined code of the frequency band and register
codes as follows are used.
For example, when sending/reading the oldest contents in
the 21 MHz band, the code “0703” is used.
• Frequency band code
• Register code
DD
Codes for memory keyer contents
To send or read the desired memory keyer contents, the
channel and character codes as follows are used.
• Channel code
• Character’s code
DD
Codes for memory name contents
To send or read the desired memory name settings, the char-
acter codes, instructed codes for memory keyer contents as
above, and follows are additionally used.
• Character’s code— Alphabetical characters
• Character’s code— Symbols
Character ASCII code Character ASCII code
a–z61–7A ——
Code Frequency band Frequency range (unit: MHz)
01 1.8 1.800000– 1.999999
02 3.5 3.400000– 4.099999
03 7 6.900000– 7.499999
04 10 9.900000–10.499999
05 14 13.900000–14.499999
06 18 17.900000–18.499999
07 21 20.900000–21.499999
08 24 24.400000–25.099999
09 28 28.000000–29.999999
10 50 50.000000–54.000000
11 144 144.000000–148.000000
12 GENE Other than above
Code Registered number
01 1 (latest)
02 2
03 3 (oldest)
Character ASCII code Description
0–930–39 Numerals
A–Z41–5A Alphabetical characters
space 20 Word space
/ 2F Symbol
? 3F Symbol
, 2C Symbol
. 2E Symbol
^ 5E e.g., to send
BT
, enter ^4254
✱ 2A Inserts contact number (can be
used for 1 channel only)
Code Channel number
01 M1
02 M2
03 M3
04 M4
Command Sub command Description
1A 0577 Send/read MONITOR level (0=0%
to 255=100%)
06 Send/read DATA mode (0=OFF,
1=ON)
07 Send/read SSB transmit band-
width (0=WIDE, 1=MID, 2=NAR)
08 Send/read DSP filter shape
(0= sharp, 1= soft)
1B 00 Set/read repeater tone frequency
(see p. 98 for details)
01 Set/read TSQL tone frequency
(see p. 98 for details)
02 Set/read DTCS code and polarity
(see p. 98 for details)
1C 00 Set/read the transceiver’s condi-
tion (0=Rx; 1=Tx)
01 Set/read antenna tuner condition
(0=OFF, 1=ON, 2=Start tuning or
while tuning)
Character ASCII code Character ASCII code
!21#23
$24%25
&26¥ 5C
?3F ” 22
’ 27 ` 60
+2B– 2D
:3A;3B
=3D<3C
>3E ( 28
)29[5B
]5D{7B
}7D|7C
_5F
–
7E
IC-7400.qxd 02.4.2 11:36 Page 97
To Next Page
Loading...
