Icom IC-7400 - Page 46

33
4
RECEIVE AND TRANSMIT
2001 NEW 2001 NEW
DD
Keyer set mode
This set mode is used to set the CW side tone, mem-
ory keyer repeat time, dash weight, paddle specifica-
tions, keyer type, etc.
• Setting contents
q Push [MENU] to select M1, then push [F4 KEY] to
select the memory keyer menu.
w Push [F5 SET] to select keyer set mode.
e Push [F1≤] or [F2 ≥] to select the desired set item.
r Set the desired condition using the tuning dial.
•Push [F3] for 1 sec. to select a default condition or value.
t Push [MENU] 2 times to return to M1.
F 1
F 2F 3 F 4 F 5
1
Set item up/down
5O%
Side
Tone Level
1. Side Tone Level
This item sets the CW side tone output level.
• 0 to 100% in 1% steps can be selected.
5O%1
Side
Tone Level
2. Side Tone L-lmt
This item sets the CW side tone level limit. When the
[AF] control is rotated above a specified level, the CW
side tone does not increase.
ON CW side tone level is limited. (default)
OFF CW side tone level is not limited.
ON2
Side
Tone L-lmt
3. Repeat Time
When sending CW using the repeat timer, this item
sets the time between transmission.
• 1 to 60 sec. in 1 sec. steps can be selected.
2s3
Repeat
Time
4. Dot/Dash Ratio
This item sets the dot/dash ratio.
• 1:1:2.8 to 1:1:4.5 (in 0.12 steps) can be selected.
Keying weight example: Morse code “K”
1:1:3.O4
Dot/Dash
Ratio
DASH
Weight setting:
1:1:3 (default)
Weight setting:
Adjusted
DASH
DOT (fixed*)
Ad
j
ustable ran
g
e SPACE
(
fixed*
)
*SPACE and DOT length can be
adjusted with [KEY SPEED] only.
IC-7400.qxd 02.4.2 11:35 Page 33