32
4
RECEIVE AND TRANSMIT
2001 NEW
DD
Contest number set mode
This menu is used to set the contest (serial) number
and count up trigger, etc.
• Setting contents
q Push [MENU] to select M1, then push [F4 KEY] to
select the memory keyer menu.
w Push [F4 001] to enter the contest number set
mode.
e Push [F1≤] or [F2 ≥] to select the desired set item.
r Set the desired condition using the tuning dial.
•Push [F3] for 1 sec. to select a default condition or value.
t Push [MENU] 2 times to return to M1.
F 1
F
2F
3
F
4
F
5
1
Set item up/down
5O%
Side
Tone
Level
2. Count Up Trig
This selects which of the four memory slots will have
the contest serial number exchange. The count up
trigger allows the serial number to e automatically in-
cremented after each complete serial number ex-
change is sent.
• M1, M2, M3 and M4 can be set. (default: M2)
1. Number Style
This item sets the numbering system used for contact
(serial) numbers— normal or morse cut numbers.
•Normal : Does not use morse cut number
(default)
•190 ANO : Sets 1 as A, 9 as N and 0 as O.
•190 ANT : Sets 1 as A, 9 as N and 0 as T.
• 90 NO : Sets 9 as N and 0 as O.
• 90 NT : Sets 9 as N and 0 as T.
3. Present Number
This item shows the current number for the count up
trigger channel set above.
•Rotate the tuning dial to change the number, or push
[F3 CLR] for 1 sec. to reset the current number to 001.
IC-7400.qxd 02.4.2 11:35 Page 32
To Next Page
Loading...
