Icom IC-R10 Instruction Manual

5
SCANNING OPERATION
45
2. Program skip setting
— cont.
When BANK R becomes full, an
error beep sounds when trying to
set more skip frequencies.
When you want to cancel the skip
function, turn OFF the SKIP setting
in the memory channel (p. 56).
t After set up, push [SCAN] or
[CLR] to stop scanning.
Stored frequencies are skipped dur-
ing the next full, program or auto-
memory write scan operation.
1. Memory skip setting
Set the skip condition in each mem-
ory channel—refer to p. 55 MEM-
ORY EDIT for details.
■ Skip function
Two skip functions are available as fol-
lows:
1. Program skip function
Used with full, program and auto-mem-
ory write scans, this function allows you
to skip specified frequencies stored in
BANK R (skip function must be ON for
these channels).
2. Memory skip function
Used with memory, BANK and mode
select scans, this function allows you to
skip specified memory channels.
These are activated when PROGRAM
SKIP or MEMORY SKIP is turned
ON in set mode (p. 59).
Their factory pre-programmed settings
are:
PROGRAM SKIP : OFF
MEMORY SKIP : ON
1. Program skip setting
q Set PROGRAM SKIP to ON in
set mode (p. 59).
w Push [V/M] to select VFO mode.
(p. 11)
e Start full or program scan (p. 35).
4 While pushing
[FUNC], push
[
(V/M)MW] during
scan pause if you
want to skip the
paused frequency.
Skip frequencies
are stored in
BANK-R memory
channels (count-
ing down from
channel 99 to 00).
PROGRAM SKIP
ON

Icom IC-R10 Specifications

General

Brand	Icom
Model	IC-R10
Category	Receiver
Language	English