Icom MR-1010RII User Manual

7
OTHER FUNCTIONS
(MENU w Initial w Range)
■ Range selection
You can customize the selectable range. If you set a
range to OFF, the range is skipped when you change
the range by pushing [+] or [–].
1. Push [MENU]/[
] to display the Menu screen.
2. Push [t] or [u] to select the Initial menu.
3. Push [p] or [q] to select the “Range” item.
4. Push [ENTER]/[ ] to enter the option selection
mode.
5. Push [p] or [q] to select the range that you want
to change the setting.
6. Push [t] to set the range to OFF, or push [u] to
set it ON.
7. Repeat steps 5 and 6 until you complete the
range selection.
L The selectable ranges are
1
⁄8,
1
⁄4,
1
⁄2,
3
⁄4, 1, 1.5, 2, 3,
4, 6, 8, 12, 16, 24, 32, 36 (NM).
8. Push [ENTER]/[ ] to save the setting.
L Do not push [CLEAR]/[ ] that exits the range
selection screen without saving the settings.
9. Push [MENU]/[ ] to exit the Menu screen.
■ Save and load settings
The MR-1010RII can save three different settings
for different operators or different situations, and
immediately change from one to another.
The save or load settings are the settings of the items
in the Color, Trail, Display, Target, ATA, AIS, Video,
and System menus.
L “Save settings” and “Load settings” are selectable only
in the Standby mode.
D Save settings
1. Push [MENU]/[ ] to display the Menu screen.
2. Push [t] or [u] to select the Initial menu.
3. Push [p] or [q] to select either the “Save
Settings1,” “Save Settings2,” or “Save Settings3”
item.
4. Push [ENTER]/[ ].
5. Push [t] to select <OK>, then push [ENTER]/
[ ] to save the settings.
6. Push [MENU]/[ ] to exit the Menu screen.
D Load settings
You can load the saved settings.
1. Push [MENU]/[
] to display the Menu screen.
2. Push [t] or [u] to select the Initial menu.
3. Push [p] or [q] to select either the “Load
Settings1,” “Load Settings2,” or “Load Settings3”
item that you want to load.
• The load item is grayed out when the settings have
not been saved.
4. Push [ENTER]/[ ] to enter the option selection
mode.
5. Push [t] to select <OK>, then push [ENTER]/
[ ].
• The selected settings are loaded.
6. Push [MENU]/[ ] to exit the Menu screen.
• Option selection mode
(MENU w Initial w Save Settings1, 2, or 3)
(MENU w Initial w Load Settings1, 2, or 3)
Push [t] or [u]
to turn ON or OFF
37

Icom MR-1010RII Specifications

General

Brand	Icom
Model	MR-1010RII
Category	Marine Radar
Language	English