Icom MR-1010RII User Manual

46
8
MENU SCREEN
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Save Settings 1 / 2 / 3
The settings can be saved. (p. 37)
1. Push [ENTER]/[
].
2. Push [t] to select <OK>.
3. Push [ENTER]/[ ] to save the settings.
Load Settings 1 / 2 / 3
The saved setting can be loaded. (p. 37)
1. Push [ENTER]/[
].
2. Push [t] to select <OK>.
3. Push [ENTER]/[ ] to load the settings.
Setting Reset
Resets the settings in the Menu screen other than
the settings in the Initial menu. You can reset only
while the MR-1010RII is in the Standby mode. (p. 38)
1. Push [ENTER]/[
].
2. Push [t] to select <OK>.
3. Push [ENTER]/[ ] to reset the settings.
Factory Reset
Resets the MR-1010RII to the factory default. You
can reset only in the Standby mode. (p. 38)
1. Push [ENTER]/[
].
2. Push [t] to select <OK>.
3. Push [ENTER]/[ ] to load the factory default.
■ AIS Own menu
Displays own AIS information.
■ Status menu
Displays the status of the GPS, Heading, AIS, and
DSC inputs, alarm settings, number of acquirable
ARPA, and CPA/TCPA alarm settings.
L The ARPA indicates the remaining number of the targets
you can acquire and then the maximum number you can
acquire. (For example, 2/5 indicates the three targets
have already been acquired, out of a maximum of 5, and
therefore two more target can be acquired.)
L The CPA/TCPA Alarm Set item indicates the number of
dangerous targets in the total number of targets.
■ Port Monitor menu
Displays the status of the input/output ports.
1. Push [p] or [q] to select the desired port.
2. Push [ENTER]/[ ] to open the detail window.
• The display status is automatically updated.
L Push [ENTER]/[
] to pause the display update.
Push again to restart.
3. Push [CLEAR]/[ ] to close the window.
■ Scanner Monitor menu
Displays the scanner status. When the status is out of
the range, the title and the value change to red color.

Icom MR-1010RII Specifications

General

Brand	Icom
Model	MR-1010RII
Category	Marine Radar
Language	English