Icom MR-1010RII User Manual

45
8
MENU SCREEN
■ System menu (Continued)
TLL Mode (Default: Output & Symbol)
Sets the action when [TLL] is held down for 1 second.
• Output: Outputs the position information where
the cursor is positioned, to the NMEA
output terminals.
• Symbol: Marks on the screen where the cursor is
positioned.
• Output & Symbol:
Outputs the position information and
marks on the screen where the cursor is
positioned.
Standby Mode (Default: Normal)
Sets the display information in the Standby mode to
Normal or AIS.
Rev.
Displays the revision number of the MR-1010RII
rmware.
■ Initial menu
Distance Unit (Default: km)
Selects the unit of distance from NM (Nautical miles)
or km (Kilometers).
L You can change this setting only while the MR-1010RII
is in the Standby mode.
Speed Unit (Default: kn)
Selects the unit of speed from kn (Knots) or km/h
(Kilometers / hour).
Date Display (Default: YYYY/MM/DD)
Selects the Date display type from “YYYY/MM/DD,”
“MM/DD/YYYY,” or “DD/MM/YYYY.”
(YYYY: Year, MM: Month, DD: Day)
Language
Selects the display language. (p. 34)
Bearing Input (Default: GPS)
Sets the input source of the vessel’s bow information.
• NMEA: NMEA0183 bearing data format.
• N+1: N+1 data format.
• AUX: Other format.
• GPS: Reads NMEA0183 COG (Course Over the
Ground) format data as HDG format. (The
course may not match with other HDG
format and includes errors.)
L When a Vessel's speed is less than 2 knots,
the direction information is not displayed until
the speed increases to more than 3 knots.
GPS-L: Reads NMEA0183 COG format data as
HDG format. (The course may not match
with other HDG format and includes errors.)
L When a vessel's speed is less than 2 knots,
thedirectioninformationinformationisxed.
The display changes only when the vessel's
speed increases to more than 3 knots.
L This is in addition to the GPS option to display
the cursor latitude and longitude when the
evessel's speed is less than 3 knots.
TX Inhibit (Default: OFF)
Selects whether the MR-1010RII uses TX inhibit or
not.
TX Inhibit Start (Default: 0°)
Sets the start point of the TX inhibit area to between
0 and 359°.
TX Inhibit Angle (Default: 1°)
Sets the TX inhibit area to between 1° and 90°.
Timing Adjust
Adjusts the sweep timing. (p. 35)
Heading Adjust (Default: 0°)
Adjusts the Bow compensation between –180° and
+180°. (p. 36)
Antenna Rotation Speed (Default: Normal)
Selects the antenna rotation speed from Normal or
Slow. (p. 35)
Range Ring (Default: Ring1)
Selects the number of displayed rings in range.
• Ring1: 2~4 rings in range.
• Ring2: 2~6 rings in range.
Range
Sets the effective ranges. (p. 37)
1. Push [ENTER]/[
] to enter the option selection
mode.
2. Push [q] or [p] to select a range.
3. Push [t] to set the range OFF or push [u] to set
the range ON.
4. Push [ENTER]/[ ] to save the settings.

Icom MR-1010RII Specifications

General

Brand	Icom
Model	MR-1010RII
Category	Marine Radar
Language	English