IDEC FT1A Series User Manual

S MART AXIS P RO /L ITE U SER ' S M ANUAL FT9Y-B1378 3-7
3: I NSTALLATION AND W IRING
Input/Output Wiring
This section describes SmartAXIS input/output device wiring.
Precautions for I/O Device Wiring
Input Terminal Wiring
When wiring input devices, separate wiring from power, output, and motor lines.
When using duct for wiring, ground piping using a D-type (type 3) ground.
When wiring DC power type models, keep wiring away from AC power lines.
When using shielded cable for wiring, ground the shield on the SmartAXIS side using a D-type (type 3) ground.
Wire input devices you want to connect to the SmartAXIS according to type as shown below.
DC Power Type
Digital Input – Sink Input
Digital Input –
Source Input
• Contact Output
External Power
Input Terminal (I*)
SmartAXIS
SmartAXIS
0V Power Supply
Terminal (
- )
0V Power Supply
Terminal (
- )
• PNP Output
External Power
Input Terminal (I*)
Output
Sensor Output
-
+
-
+
Internal Circuit
-
+
External Power
Input Terminal (I*)
SmartAXIS
0V Power Supply
Terminal (
- )
24V Power Supply
Terminal (
- )
Input Terminal (I*)
SmartAXIS
Output
- +
Internal Circuit
Internal Circuit
Input Terminal (I*)
SmartAXIS
24V Power Supply
Terminal (
- )
• Contact Output
• NPN Output
• 2-wire Sensor

IDEC FT1A Series Specifications

General

Programming Software	WindLDR
Type	Programmable Logic Controller (PLC)
Display	LCD (varies by model)
Communication Ports	RS232C/RS485 (built-in), USB (programming), Ethernet (optional)
Dimensions	Varies by model
Weight	Varies by model
Model	FT1A Series