IDEC FT1A Series - Programming Windldr (User Communication Server)

9: M AINTENANCE C OMMUNICATION
9-6 S MART AXIS P RO /L ITE U SER ' S M ANUAL FT9Y-B1378
Programming WindLDR
This section describes the procedures to configure the maintenance communication server for the Ethernet port and communicate
with the SmartAXIS via Ethernet.
Configure Maintenance Communication Server
1. From the WindLDR menu bar, select Configuration > Network Settings.
The Function Area Settings dialog box appears.
2. Enter the IP address, subnet mask, and default gateway.
3. Click Connection Settings.
4. In the Communication Mode pull-down list for the connection to configure, select Maintenance Communication Server.
The Maintenance Communication Server dialog box appears.