6: HMI F
UNCTION
6-8 S
MART
AXIS P
RO
/L
ITE
U
SER
'
S
M
ANUAL
FT9Y-B1378
SmartAXIS Environment Settings
When the SmartAXIS is stopped, you can configure the menu language, internal clock, slave number, and the scroll unit/speed and
blinking speed for messages displayed with the message (MSG) instruction/FB. These cannot be configured while the SmartAXIS is
running.
Changing the Menu Language
When the SmartAXIS is stopped, you can change the menu language between Japanese, English, and Chinese. This cannot be
changed while the SmartAXIS is running. The menu language is set to English when the SmartAXIS is shipped from the factory, so
this section describes how to switch the language to Japanese.
1. On the standard screen, press the (ESC) + (OK) buttons.
The system menu is displayed.
2. Select Configurations with the (up) and (down) buttons and press the (OK) button.
3. Select Menu Languages and press the (OK) button.
4. Select Japanese with the (down) button, and then press the (OK) button to confirm.
• Selectable menu languages
The menu languages that can be selected are as follows.
English/Japanese/Chinese
• Retaining the menu language setting
For system software version V2.20 and later, the menu language setting is retained in the ROM of the SmartAXIS. Even if the
backup battery is dead, it is not required to change the menu language again.
6WRSSHG
-$16$7
Run
Edit Program
External Memory
Configurations
Function
Clock
Menu Languages
Backlight
To Next Page
Loading...
Need help?
General
