IDS X64

Section: 10
IDS X64 User Manual 700-398-01D Issued August 2010
21
10.
User Program Options
The IDS X64 Alarm Panel has 128 programmable user codes. By default, user code 1 is the Master User
Code that contains a pre-programmed 4-digit code of 1234.
NOTE:
User codes may be 4 (default) or 6 digits long (with a default code of 123456). This is a programmable
feature. Check with your installer to verify which option has been programmed.
10.1
Adding, Deleting and Editing User Codes
Hold down the [*] key until the beep,
then enter [MASTER CODE] [*] [PROGRAMMABLE OPTION] [*]
The IDS X64 Panel has a friendly programmable interface that allows you to add, modify or delete user
codes. See Table 5 for a summary of programmable options. The programmable interface is accessed
by entering the USER PROGRAMMING MODE where it is possible to change user options.
Table 5:
User Programming Options
Options
Summary of Programmable Options
Option 0
Allows for the addition of new user codes.
Option 1
Allows for the editing of a selected user code.
Option 2
Allows for the deletion of user codes.
Option 3
Allows for the adding/editing of slots.
Option 4
Allows for the deletion of a user code using the user code slot number.
Option 5
Allows for the viewing of the user code slot number for a selected code.
There are 128 available user code slots.
Option 10
Allows for the editing of the user code properties for a selected user code.
10.2
Advanced User Options
Refer to Table 6 for advanced user options.
Table 6: Advanced Programming Options
Options
Summary of Programmable Options
Option 11
Allows for the allocation of a selected user code to a designated
partition(s).
Option 13
Allows for the editing of user outputs.
Option 14
Allows for the editing of reporting codes.
Option 15
Allows for the editing of reporting code modules.
Option 20
Allows for the basic adding of remotes.
Option 21-29
Please consult the X64 Remote Receiver Manual
Option 30
Please consult the X64 LCD Keypad Manual