IDS X64 - 12.5 Delete a User Code - Option 4 (Slot Known); 12.6 View a User Code Slot Number - Option 5

Section: 12
IDS X64 User Manual 700-398-01D Issued August 2010
24
9. Press the [#] key to exit the current option.
10. Press the [OPTION NUMBER] followed by the [*] key for the next option, or the [#] key again
to exit user programming.
NOTE:
A slot is just a place holder number for a user code. I.e. User code 1 is in slot 1; all the way to user code
128 is in slot 128.
12.5
Delete a User Code – Option 4 (Slot Known)
Hold down the [*] key until the beep,
then enter [MASTER CODE] [*] [4] [*] [SLOT NUMBER] [*] [#]
1. Enter the User Program Mode as per steps 1 to 4 in section 11.
2. Press the [4] key followed by the [*] key to select Menu option 4.
3. The ARM and READY LEDs flash simultaneously.
4. Enter the [SLOT NUMBER] for the user code you wish to delete followed by the [*] key. You
can determine the slot number of a particular code by using programmable option 5.
5. The READY and ARM LEDs flash simultaneously.
6. Further user codes may be deleted by repeating step 4.
7. Press the [#] key to exit the current option.
8. Press the
[OPTION NUMBER]
followed by the
[*] key for the next option, or the [#] key again
to exit user programming.
NOTE:
A slot is just a place holder number for a user code. I.e. User code 1 is in slot 1; all the way to user code
128 is in slot 128.
12.6
View a User Code Slot Number – Option 5
Hold down the [*] key until the beep,
then enter [MASTER CODE] [*] [5] [*] [USER CODE] [*] [#]
1. Enter the User Program Mode as per steps 1 to 4 in section 11.
2. Press the [5] key followed by the [*] key to select programmable option 5.
3. The READY and ARM LEDs flash simultaneously.
4. Enter the [USER CODE] followed by the [*] key.
5. The READY and ARM LEDs flash simultaneously.
6. The User Code slot number will be displayed by the Zone LEDs. (Refer to Table 2.)
7. Press the [#] key to exit the current option.
8. Press the [OPTION NUMBER] followed by the [*] key for the next option, or the [#] key again
to exit user programming.
NOTE:
A slot is just a place holder number for a user code. I.e. User code 1 is in slot 1; all the way to user code
128 is in slot 128.