IDS X64 - System Time and Date Editing; 12.14 Edit the Time - Option 40

Section: 12
IDS X64 User Manual 700-398-01D Issued August 2010
30
7. The READY and AWAY LEDs flash simultaneously, and the ARM LED will be on.
8. Repeat step 6 until you have selected all the modules that you want.
9. Press the [#] key to exit the current option.
10. Press the [OPTION NUMBER] followed by the [*] key for the next option, or the [#] key again
to exit user programming.
Table 13: Specify which Telephone Module to use
LED
On / Off
Action
1
ON
Telephone Module 2
OFF
Telephone Module 1
2
ON
Telephone Module 2
OFF
Telephone Module 1
3
ON
Telephone Module 2
OFF
Telephone Module 1
4
ON
Telephone Module 2
OFF
Telephone Module 1
NOTE:
The options are only available if the corresponding option in Option 14 is on.
EXAMPLE:
If the close reporting code is disabled, then you will not be able to set the telephone module for it. If it is
enabled, then you can choose between telephone module 1 and 2.
12.12
Remote Receiver – Options 20 – 29 (Advanced)
Refer to the X64 Remote Receiver Manual for the available user options that can be programmed.
12.13
LCD Keypad – Option 30 (Advanced)
Refer to the X64 LCD Keypad Manual for the available user option that can be programmed.
12.14
Edit the Time - Option 40
Hold down the [*] key until the beep,
then enter [MASTER CODE] [*] [4] [0] [*] [TIME] [*] [#]
1. Enter the User Program Mode as per steps 1 to 4 in section 11.
2. Press the [4] [0] keys followed by the [*] key to select programmable option 40.
3. The READY and ARM LEDs flash simultaneously.
4. Enter the [TIME]
that you wish to edit.
5. The time format is 24 hours, [HHMM].
6. To confirm the entry press [*].
7. The READY LED flashes.
8. Press the [OPTION NUMBER] followed by the [*] key for the next option, or the [#] key again
to exit user programming.