IDS X64 - 12.15 Edit the Date - Option 41; Stay Zones; 13.1 How to Select a Stay Profile

Section: 12
IDS X64 User Manual 700-398-01D Issued August 2010
31
12.15
Edit the Date - Option 41
Hold down the [*] key until the beep,
then enter [MASTER CODE] [*] [4] [1] [*] [DATE] [*] [#]
1. Enter the User Program Mode as per steps 1 to 4 in section 11.
2. Press the [4] [1] keys followed by the [*] key to select programmable option 41.
3. The READY and ARM LEDs flash simultaneously.
4. Enter the [DATE]
that you wish to edit.
5. The date format is [DDMMYY].
6. To confirm the entry press [*].
7. Press the [OPTION NUMBER] followed by the [*] key for the next option, or the [#] key again
to exit user programming.
13.
Stay Zones
Stay zones are those zones that are bypassed automatically when the system is “STAY ARMED”. Any
zone that should not trigger an alarm when violated in stay mode must be programmed as a stay zone.
Stay zones need only be programmed once. Each time the system is armed in the Stay Mode the pre-
selected stay zones will be bypassed automatically. The panel allows for 4 unique STAY PROFILES to be
stored, consisting of a pre-selected combination of STAY and BUZZ zones, to suit a specific STAY ARM
requirement. STAY and BUZZ zones can be programmed for each profile only once the particular profile
has been selected. See section 13.2.
NOTE:
Stay arming with the [5] key does not change the current stay profile.
However, if a partition is stay armed using Stay Profile 1, it is possible to toggle the panel directly to Stay
Arm Profile two by holding the [5] key for two seconds until a beep is heard.
EXAMPLE:
¾ Stay Profile 1 – used for when the family has gone to bed, and only the bedroom zones are
bypassed.
¾ Stay Profile 2 – used for family time at home. All internal zones are bypassed; but the window,
door, and outdoor zones are armed.
¾ Stay Profile 3 – used for during the day when there is activity. In this instance, only the perimeter
will be armed.
13.1
How to Select a Stay Profile
Quick Select Method (LCD only):
Press the [5] key simultaneously with the [STAY PROFILE NUMBER] and release
1. Ensure that the Panel is disarmed.
2. Press the [#] key to clear any previous entries.
3. Press the [5] key and then simultaneously press keys [1], [2], [3], or [4] – depending on the
stay profile you want to choose – then release both keys.
4. A beep will sound to indicate successful selection of a profile (an LCD keypad will also display
the profile number).