IDS X64 - Page 43

IDS X64 User Manual 700-398-01D Issued August 2010
43
Toggle Outputs
[Mode] [3] [*] [1, 2, 3, 4 or 5] [*]
1 – 5 is onboard outputs 1 – 5
Bypassing
/Un-bypassing a Zone
[9]
[Master Code] [*] [Zone Number] [*]
Alarm Memory
[0]
Displays zones violated.
View Trouble Condition
s
[7]
1 = AC Mains Fail
2 = No Communication
3 = Phone Line
4 = Siren Tamper
5 = Low Battery
6 = 12V Aux Fuse
7 = Engineer Reset
8 = Box Tamper
9 = Tamper on Peripheral Device
10 = Comms Loss to Peripheral Device
11 = Loss of Power to Peripheral Device
12 = EEPROM Failure
NOTE:
The first key pressed in any programming sequence needs to be held down until the beep is heard.