MAINTENANCE
• Clean
the
Fuel
Filter
Element
~-------
--------....,.
* Hot oil and components can cause personal injury.
* Fuel leaked or
spilled
on to hot surfaces can cause a
fire.
The fuel filter is located rear
of
the engine.
1.
Stop the engine.
2.
Turn the fuel stop lever
CD
to the "closed" (OFF) position.
3.
Loosen the ring nut
(?)
4.
Remove the cup ® and the element @
5.
Drain water and sediment into a suitable container.
NOTE: Always dispose
of
drained fluids as established by
local regulations.
6.
Clean the inside surface
of
the cup and the element @
7.
Install the clean element ®
8.
Install cup
®.
Tighten ring nut
(?)
9.
Turn the fuel stop lever
CD
to the "opened" (ON) position.
NOTE: Do not start the engine until all fuel system service
is
completed.
•
Priming
the
system
There should be enough fuel
in
the system to allow the
engine to start. Keep the engine start switch key at ON for
a period
of
20 seconds, which operates the fuel pump and
priming automatically.
• Change the
Coolant
Coolant should be drained and changed every 250 service
hours or six months. However, when adding "Long-Life-
Coolant", the drain period can be extended to 2 years.
Drain the coolant earlier whenever the coolant is dirty or
foaming
is
observed.
See 2 years Maintenance section.
4-7-5
17VX3
250 HOURS
To Next Page
Loading...
