MAINTENANCE
• Walk-Around Inspection
Inspect the operator's compartment for cleanliness. Keep it
clean.
Inspect the loose bolts, Tighten any loose bolts. Repair if
necessary
..
Inspect any cracks
in
boom and arm pivot area and cylinder
mounting brackets.
Repair if damaged.
Inspect attachment cylinders, linkage and bucket for damage
or excessive wear. Repair if damaged.
Inspect and remove any trash build up
in
the engine
compartment.
Inspect the cooling system for leaks, faulty hose and trash
built
up.
Correct any leaks and remove any trash from the
radiator.
Inspect the hydraulic system for leaks. Inspect the tank,
cylinder
rod
seals. tubes, plugs, joints and fittings. Correct
any leaks.
Inspect and repair travel drive leaks. Check oil level if
leakage
is
noticed.
• Daily Lubrication
Perform the daily lubrication as required by the Lubrication
Chart.
4-5-4
17VX3
DAILY
To Next Page
Loading...
