EasyManua.ls Logo

ikeGPS ike100 - Protecting the Touchscreen; Protecting Your Ike against Mechanical Shock; Equipment Warnings

Default Icon
132 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.ikegps.com/quickstart Page 77 www.ikegps.com/support
2. Press the Task Manager button to close all running application programs.
3. Charge the battery pack to full capacity (100%).
4. Unplug the wall charger. Press the Power button until the Power Button menu appears.
5. Select Power Off from the menu, and then tap OK.
6. Place your ike in a safe, dry place.
Taking your ike out of extended storage: The battery pack discharges slightly during
extended storage periods. When you are ready to use your ike again, follow these steps so
your battery pack runs efficiently:
Plug your ike into a charger.
Charge the battery pack. (To check the battery power status, tap on the battery icon
at the top of the screen.)
Only charge the battery pack in temperatures between 32°F and 104°F (0°C and 4C).
For best results, charge the battery pack at room temperature (6F or 20°C)
Protecting the touchscreen
Protect the touchscreen from impact, pressure, or abrasive substances that could damage
it. To further protect the touchscreen, a tested screen protector accessory is available
from your ike
GPS
reseller.
CAUTION: Be sure to replace the screen protector as often as the screen protector
manufacturer packaging directs.
To apply a screen protector, follow these steps:
1. Make sure your ike is free of oils and dirt. You can wipe it with a microfiber cloth.
2. Fit the screen protector onto your ike screen in accordance with the supplied installation
instructions.
3. Smooth the screen protector while peeling back the liner, working out air bubbles as you
go. Continue smoothing until the liner is removed.
Note: Some air bubbles may still be visible, but they fade away in a short time. You can
use a credit card to gently push out any excess air.
Protecting your ike against mechanical shock
ike is designed for protection from mechanical shock. It has been test-dropped from five
feet (1.524m) onto concrete. Shock protection is guaranteed only when the entire body
molding (including SD Card cover and Connector protector) is securely in place.
Equipment warnings
WARNING! To reduce the risk of personal injury, electrical shock, fire or damage to the
equipment:
Plug the wall charger into an electrical outlet that is easily accessible at all times.
Disconnect power from the equipment by unplugging the wall charger from the electrical

Table of Contents