www.ikegps.com/quickstart Page 45 www.ikegps.com/support
Span Height
Summary
In Span Height mode is used to calculate the vertical height above ground of a point on a span,
for example the mid-span height of a cable or wire.
The user is guided through a series of steps to allow a measurement of the vertical distance
between (for example) a suspended wire and the (reasonably level) ground below.
When performing span height measurements, the use of an ike low Magnetic Signature Tripod
is strongly recommended as this will assist in minimizing potential error introduced due to
changing the hand-held height of the ike during the measurement.
Step-by-step
Select the Span Height ikeTool from the Home menu
To Next Page
Loading...