www.ikegps.com/quickstart Page 93 www.ikegps.com/support
Using the documentation
Your ike unit is provided with reference tools that are primarily available from ike
GPS
.
These tools include:
This User Manual
Optional ‘ike Software CD’ containing ikeOS/software installers, user
manuals/guides, license files and other materials specific to your ike purchase.
On-device help files
Use the following chart to find the additional information you may require:
Instructions for setting up ike
Instructions for using external devices with your
ike
Instructions for basic tasks such as replacing
battery packs, resetting the device, adjusting the
backlight, or inserting memory cards
Instructions for using programs installed on ike
Help files located within
individual programs on ike
Windows
®
Mobile Device Center for Windows
Vista/7
™
users
Microsoft Website - WMDC 6.1
32-bit version for 8/7/Vista
or
Microsoft Website - WMDC 6.1
64-bit version for 8/7/Vista
ActiveSync
®
install for Windows
®
XP users
Microsoft Website -
ActiveSync 4.5 for XP
Getting Started
This section repeats some the instructions from the ‘Getting Started’ section of the
Introduction chapter.
Step 1: Install the battery
1. Carefully unhook and lift up the bottom hook of the hand strap.
WARNING! Releasing the hand strap hook too quickly may result in injury or
damage to the display. Use caution when undoing the hook or when holding
your ike by its hand strap.
2. Press on the battery door and slide the door latch to the right to unlock it, as shown in
the second picture.
3. Remove the battery door.
4. Insert the battery pack so battery contacts match up.
5. Insert the tabs on the bottom of the battery door into the case slots. Close the battery
door.
6. Press on the battery door. Slide the latch to the left to lock it.
7. Reattach the hand strap.
To Next Page
Loading...