IKONIX apt 400XAC Series - MAC Address; Barcode Input

134
When the Device Name has been entered, press the Enter soft key to save the
new settings. The Device Name parameter is only active when the IP Setup is set
to AUTO.
10.3.10 MAC Address
View the MAC address of the Ethernet Card here. This parameter is not
adjustable.
10.3.11 Barcode Input
Highlight the Barcode INPUT parameter using the ,  soft keys. When the
Barcode INPUT parameter is highlighted, press the Edit soft key.
The Barcode INPUT parameter can be set to SERIAL#, PRODUCT#,
SER/PROD, OFF or RUN FILE.
When the setting is SERIAL#, PRODUCT# or SER/PROD, the user can scan
barcodes in the Perform Tests screen before the test is started. When a barcode
is scanned, one of the following messages will appear on the display.