Transient = indicates the Transient mode that is programmed into the instrument.
Transient Mode: indicates the Transient mode that can be programmed into the
instrument.
The Transient modes available are ON and OFF. Press the Change soft key to
toggle the mode to ON or OFF. To save the parameter, press the Enter soft key.
To cancel the editing of the Transient mode press, the Esc soft key. When the
Enter soft key is pressed the Transient mode is accepted and you transition into
the next parameter: Trans-Volt*.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
*If the Transient parameter is turned ON additional parameters of Trans-Volt,
Trans-Site, Trans-Time, and Trans-Cycle will be present in the Test Parameters
screen.
4.6.8 Editing Trans-Volt* (PROGRAM Mode only)
Use the , soft keys to navigate to the Trans-Volt parameter (only selectable for
AC output). Pressing the Edit soft key will provide the following screen:
Trans-Volt = indicates the Trans-Volt that is programmed into the instrument.
Transient Voltage Range: indicates the transient voltage range that can be
programmed into the instrument.
To Next Page
Loading...
Need help?
General