is pressed the Mem Lock Mode is accepted and you transition into the next
system parameter: Volt Sense.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
4.3.16 Editing Volt Sense
Use the , soft keys to navigate to the Volt Sense parameter. Pressing the Edit
soft key will provide the following screen:
Volt Sense = indicates the voltage sense that is programmed into the instrument.
Voltage Sense Mode: indicates the voltage sense mode that can be programmed
into the instrument.
The Volt Sense Modes available are INT and EXT. Press the Change soft key to
toggle the mode to INT or EXT. To save the parameter, press the Enter soft key.
To cancel the editing of the Volt Sense Mode, press the Esc soft key. When the
Enter soft key is pressed the Volt Sense Mode is accepted and you transition into
the next system parameter: Sync Signal.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
4.3.17 Editing Ext Trig
Use the , soft keys to navigate to the Sync Signal parameter. Pressing the
Edit soft key will provide the following screen:
To Next Page
Loading...
Need help?
General